%{tishi_zhanwei}%

Keyword suggestions: Emergency Exit Lock Series | Handle Lock Series | Floor Spring Series | Hinge Series

Service Support

FAQ


Image Name

Does the lock automatically relock, and do you often accidentally lock it when you leave?


Image Name

The lock cylinder spring is too strong, or the door gap is too wide. Adjust the door gap, replace the spring with one of appropriate tension, and remember to carry your key when you leave.

Image Name

Can’t turn or the handle lock is stuck?


Image Name

The cabinet body is subjected to compressive stress on the lock mechanism. Gently push the door before unlocking, loosen the hinge screws to adjust the door gap, and clean the lock cylinder regularly.

Image Name

Can’t turn the key after installing a new lock?


Image Name

The lock cylinder is misaligned. Remove the faceplate, reposition the cylinder correctly, and ensure the key is fully inserted before turning it. Do not force the key by twisting it with excessive force.

Image Name

Is the lock rusty and not closing tightly? Does it often break when exposed to rain?


Image Name

Outdoor locks have poor water resistance; wipe off any rust and apply a rust remover. For outdoor use, it’s recommended to replace them with stainless steel, rust‑proof locks and install a door canopy to shield them from rain.

Image Name

Can’t open the bathroom door after it’s been locked from the inside with no key?


Image Name

Use a thin piece of wire or a paperclip to insert into the emergency pinhole on the side of the door lock, then press inward to unlock. In daily use, avoid striking the lock with excessive force.
 

Image Name

Is the door handle hard to push down, causing the door to open with a jerky, uneven motion?


Image Name

Most lock bodies lack lubrication or have loose screws. Tighten the mounting screws and apply a small amount of graphite grease to the lock’s pivot shaft and handle‑to‑body joint—do not use cooking oil, as it can attract dust and form clumps.

< 12 >